Post by felito0398 on May 3, 2015 1:13:18 GMT -5
I have a drive board with the same blown transistor. I tried replacing the Q2 and the board did not work. I purchased a replacement The replacement board does not match the original. The power and ground connections are on different pins on the new board and it has an additional connector JP3 which is not on the original board. . JP3 has 6 pins on the new board and 4 on the original. Last month I put pics and part numbers of both boards in aletter to Meade tech support, no answer.
It would be good to have real support from Meade, a schematic would be even better.
Does anyone know if a LX90 motor drive w GPS part no 15-4513-02 rev a can be used to replace part no 15-4513-00 rev E and how to connect the board to the wiring harness without shorting the +!2?
thanks,
felito0398
It would be good to have real support from Meade, a schematic would be even better.
Does anyone know if a LX90 motor drive w GPS part no 15-4513-02 rev a can be used to replace part no 15-4513-00 rev E and how to connect the board to the wiring harness without shorting the +!2?
thanks,
felito0398